/challenges-projects/design-challenges/forget-me-not/b/blog/posts/review-of-tektronix-tbs1052b-eduHere’s my (quite) brief review of the oscilloscope received as part of the Forget Me Not -challenge, which includes using the scope to measure powering of the Pi B+ with a cheap DC/DC converter. The review is written as a flow of mind, so I&#39;m fairly en-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/forget-me-not/b/blog/posts/review-of-tektronix-tbs1052b-eduFri, 29 Aug 2014 12:14:49 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:d0ca78dd-93fc-4864-8f8c-bd9544639513kipe0<p>Ok, good to know.</p><p>I also noticed, that the 2.52 seemed to fix the issues with toggling measurements; seems to work as it should now (not closing the menu after selecting one, at least not when the measurement is paused).</p><img src="https://community.element14.com/aggbug?PostID=18489&AppID=100&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/challenges-projects/design-challenges/forget-me-not/b/blog/posts/review-of-tektronix-tbs1052b-eduFri, 29 Aug 2014 09:54:25 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:d0ca78dd-93fc-4864-8f8c-bd9544639513hlipka0<p>One note: the snapshot function you described seems to be only function properly with an updated firmware. When I got my scope FW version 2.52 was marked as available on the Tektronix website, but it took two days or so to be downloadable, so I tested with version 2.02. And there the snapshot function always showed an error like &#39;the snapshot is not ready yet&#39; or so.</p><img src="https://community.element14.com/aggbug?PostID=18489&AppID=100&AppType=Weblog&ContentType=0" width="1" height="1">