/challenges-projects/design-challenges/forget-me-not/b/blog/posts/forget-me-not---5---designing-a-home-automation-add-on-for-the-pi-part-1ForewordAs I (might) have mentioned before, the initial reason why I got into home automation was the house my dad built in the middle of nowhere. The current system is based heavily on 1-Wire , which is pretty much a wired equivalent for EnOcean stanen-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/forget-me-not/b/blog/posts/forget-me-not---5---designing-a-home-automation-add-on-for-the-pi-part-1Fri, 26 Sep 2014 06:08:06 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:895b2ffe-20e9-4acf-92b6-fb8d1bff1bc4mcb11<p>Nice work.</p><p>I like the separate watchdog ... it gives reasonable peace of mind.</p><p>&nbsp;</p><p>&nbsp;</p><p>Mark</p><img src="https://community.element14.com/aggbug?PostID=18726&AppID=100&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/challenges-projects/design-challenges/forget-me-not/b/blog/posts/forget-me-not---5---designing-a-home-automation-add-on-for-the-pi-part-1Thu, 25 Sep 2014 20:48:31 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:895b2ffe-20e9-4acf-92b6-fb8d1bff1bc4kipe0<p>Also, as a minor note: My scope broke (I think the EEPROM holding calibration data, serial number etc failed) and is now off to Germany for service. This did slow down the progress today a bit, as I got used to it already <span>[View:/resized-image/__size/16x16/__key/commentfiles/f7d226abd59f475c9d224a79e3f0ec07-895b2ffe-20e9-4acf-92b6-fb8d1bff1bc4/contentimage_5F00_403.png:16:16]</span></p><p>I ran into some problems which could have been easily found with a scope, but unfortunately this wasn&#39;t possible...</p><img src="https://community.element14.com/aggbug?PostID=18726&AppID=100&AppType=Weblog&ContentType=0" width="1" height="1">