In The Air: Episode 6 - Getting Ready For PCBs

RE: In The Air: Episode 6 - Getting Ready For PCBs

DAB — Thu, 11 Dec 2014 20:00:50 GMT

Nice update.

DAB

RE: In The Air: Episode 6 - Getting Ready For PCBs

ipv1 — Thu, 11 Dec 2014 13:41:55 GMT

Well I didn't cut the slots either and again for the basic reason that I shoved it so far away that nothing with interfere. No copper pours except for the ground one and the sensor is on the edge so it does its job right.

[View:/resized-image/__size/16x16/__key/commentfiles/f7d226abd59f475c9d224a79e3f0ec07-a8a143c8-80b3-4be8-8cb6-169d75e44df6/contentimage_5F00_1.png:16:16] Hope it works.

RE: In The Air: Episode 6 - Getting Ready For PCBs

shabaz — Thu, 11 Dec 2014 13:29:33 GMT

Hi Michael,

Looking forward to seeing the board in action : ) I imagine you can't wait either.

Also, excellent points!! Most of the time the first read of the datasheet doesn't get absorbed. I always have to go back and re-read at least once more.

Also, often component manufacturers are nice and happy to review designs, so this helps too.

RE: In The Air: Episode 6 - Getting Ready For PCBs

ipv1 — Thu, 11 Dec 2014 06:40:20 GMT

We can get entire kits?