/challenges-projects/design-challenges/in-the-air-design-challenge/b/blog/posts/in-the-air-episode-7---still-getting-ready-for-pcbsPrevious Posts: In The Air: Epidose 1: Introduction In The Air: Episode 2 - Preparing for Surface Mount Work In The Air: Episode 3 - Surface Mount Beginnings In The Air: Episode 4 - Inductors In The Air: Episode 5 - PCB Design In The Air: Episode 6 -en-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/in-the-air-design-challenge/b/blog/posts/in-the-air-episode-7---still-getting-ready-for-pcbsSun, 21 Dec 2014 21:47:17 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:544bf8d0-2d36-4a98-97e8-8c0216bb4b63shabaz0<p>Hi Michael,</p><p>&nbsp;</p><p>I just saw your post, as you say it may be related to newer software. I didn&#39;t need to make changes in Device Manager. It might also be related to types of USB chipset on the PC perhaps. I used ports that were 3.0 compatible in 2.0 mode. With other (non-TI) boards in the past I found I needed to use USB 2.0-only ports.</p><img src="https://community.element14.com/aggbug?PostID=19494&AppID=102&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/challenges-projects/design-challenges/in-the-air-design-challenge/b/blog/posts/in-the-air-episode-7---still-getting-ready-for-pcbsFri, 19 Dec 2014 03:01:34 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:544bf8d0-2d36-4a98-97e8-8c0216bb4b63jw07521<p>Hi Michael, Nice looking board and it arrived very fast. It seems that I just read your blog where you were planning it.</p><p>John</p><img src="https://community.element14.com/aggbug?PostID=19494&AppID=102&AppType=Weblog&ContentType=0" width="1" height="1">