/challenges-projects/design-challenges/inductive-sensing/b/blog/posts/inductive-sensing-design-challenge-usb-microphone-based-on-the-ldc1000-inductance-to-digital-converter-week-5This week I focused mostly on the software for the LDC1000EVM. There are many questions on the ask TI forum about the protocol which is used on the LDC1000EVM, but there is no real single answer. What is known is that the LDC1000EVM uses a USB CDC (Cen-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/inductive-sensing/b/blog/posts/inductive-sensing-design-challenge-usb-microphone-based-on-the-ldc1000-inductance-to-digital-converter-week-5Fri, 30 May 2014 20:14:59 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:7c83e7ef-e70d-49c8-9785-0505df6444f8DAB1<p>Hi Sammy,</p><p>&nbsp;</p><p>Good post.</p><p>Is the linearity of detection distance due to the algorithm in the sensor or just the signal response from the software?</p><p>I wonder if you can set up the sensor to a log scale so that you can get higher resolution over a smaller range?</p><p>&nbsp;</p><p>DAB</p><img src="https://community.element14.com/aggbug?PostID=17798&AppID=111&AppType=Weblog&ContentType=0" width="1" height="1">