/challenges-projects/design-challenges/pathtoprogrammable/b/blog/posts/minized-with-td114-caseI made up a new case for the MiniZed with the video card installed. I need to revise the cover with cutouts for the USB connector and the two jumpers on the video board. Each half was a 5 hour print. Scotten-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/pathtoprogrammable/b/blog/posts/minized-with-td114-caseFri, 18 Jan 2019 22:55:52 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:71bc86bd-a76b-487d-8420-8ff69b8c50fbaspork420<p>Wow! 5 hours seems a little excessive... But I have slowed my printer down in recent times since I seem to have better luck and fewer failed prints. Nice job, though!</p><img src="https://community.element14.com/aggbug?PostID=6330&AppID=209&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/challenges-projects/design-challenges/pathtoprogrammable/b/blog/posts/minized-with-td114-caseTue, 15 Jan 2019 09:04:46 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:71bc86bd-a76b-487d-8420-8ff69b8c50fbsnidhi1<p>I was just thinking that wouldn&#39;t you need a heat sink on top of the fpga. Given that the fpga chip gets pretty hot and the casing is plastic with no place for air-circulation. </p><p>&nbsp;</p><p>Cheers</p><img src="https://community.element14.com/aggbug?PostID=6330&AppID=209&AppType=Weblog&ContentType=0" width="1" height="1">