/challenges-projects/design-challenges/pi-iot/b/blog/posts/pi-iot-thuis-6-installing-the-raspberry-pi-3-in-practiceLast week I explained how I&#39;m using Chef to provision my Raspberry Pi&#39;s and the recipes in my Thuis cookbook . Back then I didn&#39;t have a Raspberry Pi 3 yet, so I tested it on an older model. This week the kit arrived, so I&#39;ll bring the bootstrapping ien-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/pi-iot/b/blog/posts/pi-iot-thuis-6-installing-the-raspberry-pi-3-in-practiceSun, 26 Jun 2016 13:08:57 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:28a90527-4cb9-4aa9-b676-3f3c59c8ee57fvan2<p>Did you try the <em>&quot;enable_uart&quot;</em> property in the <em>&quot;/boot/config.txt&quot;</em>? It restores the UART, and keeps the BT operational. The UART interface is then <em>&quot;ttyS0&quot;</em> instead of <em>&quot;ttyAMA0&quot;</em> though.</p><p>It&#39;s described in my EnOceanPi paragraph: <a class="jive-link-blog-small" href="/challenges-projects/design-challenges/pi-iot/b/blog/posts/pi-iot-alarm-clock-05-enocean-pi-and-sensors#jive_content_id_EnOceanPi" title="https://www.element14.com/community/community/design-challenges/pi-iot/blog/2016/06/14/pi-iot-alarm-clock-05-enocean-sensors#jive_content_id_EnOceanPi">https://www.element14.com/community/community/design-challenges/pi-iot/blog/2016/06/14/pi-iot-alarm-clock-05-enocean-sen…</a> </p><p>&nbsp;</p><p>Frederick</p><img src="https://community.element14.com/aggbug?PostID=1637&AppID=138&AppType=Weblog&ContentType=0" width="1" height="1">