/challenges-projects/design-challenges/pichef/b/blog/posts/the-cooker-connector---blog-7-pcb-design-pi-chef-challengeTime is flying by! There’s less than one month left in the Pi Chef Challenge. If you’re not familiar with my Cooker Connector project, have a look at my project proposal . An essential part of my project is a Printed Circuit Board for my Sensor Hub, aen-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/pichef/b/blog/posts/the-cooker-connector---blog-7-pcb-design-pi-chef-challengeMon, 05 Mar 2018 21:55:25 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:ee653af8-bacb-43ce-9345-1497c8046b2cthree-phase0<p>Interesting blog about the PCB design process. Look forward to seeing it being populated and tested. </p><p>&nbsp;</p><p>Thanks for posting.</p><p>&nbsp;</p><p>Kind regards</p><img src="https://community.element14.com/aggbug?PostID=4370&AppID=183&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/challenges-projects/design-challenges/pichef/b/blog/posts/the-cooker-connector---blog-7-pcb-design-pi-chef-challengeMon, 05 Mar 2018 01:34:10 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:ee653af8-bacb-43ce-9345-1497c8046b2cgenebren1<p>Jonathan,</p><p>&nbsp;</p><p>Great update on your project! Very clear and methodical. I was a little confused as to why you would put 4 headers for servos and have them all feed off the same PWM signal, running them in parallel?&nbsp; I will have to try OSH Park sometime.&nbsp; I have friends that swear by it.</p><p>&nbsp;</p><p>Keep up the good work, I can almost smell the sweet scents of BBQ from here.</p><p>Gene</p><img src="https://community.element14.com/aggbug?PostID=4370&AppID=183&AppType=Weblog&ContentType=0" width="1" height="1">