/challenges-projects/design-challenges/sci-fi-your-pi/b/blog/posts/meditech-control-panel-pcb-and-circuit-installationPCB prototypingAfter a final check the schematic is expected following the previous tests done with wires and breadboards so the final PCB prototype has been milled as shown in the images below. As shown in the final circuit assembled image, only theen-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/sci-fi-your-pi/b/blog/posts/meditech-control-panel-pcb-and-circuit-installationWed, 10 Jun 2015 20:26:10 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:a4296bfd-27cf-43ee-8e24-7301e3e4485escreamingtiger1<p>Did you mill this board or have it sent off?&nbsp; Also what software do you use?&nbsp; I need to get a PCB software.</p><img src="https://community.element14.com/aggbug?PostID=21046&AppID=119&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/challenges-projects/design-challenges/sci-fi-your-pi/b/blog/posts/meditech-control-panel-pcb-and-circuit-installationTue, 09 Jun 2015 20:13:43 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:a4296bfd-27cf-43ee-8e24-7301e3e4485ebalearicdynamics0<p><strong>Board issue</strong></p><p>&nbsp;</p><p>While testing the final version I have found an issue due a mistake on the schematics (I will correct the related post asap). The pull-up resistor in the LID switch was placed in the wrong place so the result is that the lid switch appears always open instead of detecting the real status. Just done a pcb correction <em>on-the-fly</em>.</p><p>&nbsp;</p><p><span>[View:/resized-image/__size/1200x899/__key/commentfiles/f7d226abd59f475c9d224a79e3f0ec07-a4296bfd-27cf-43ee-8e24-7301e3e4485e/contentimage_5F00_179153.jpg:1200:899]</span></p><img src="https://community.element14.com/aggbug?PostID=21046&AppID=119&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/challenges-projects/design-challenges/sci-fi-your-pi/b/blog/posts/meditech-control-panel-pcb-and-circuit-installationTue, 09 Jun 2015 20:00:25 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:a4296bfd-27cf-43ee-8e24-7301e3e4485efvan1<p>Excellent work as usual, Enrico!</p><img src="https://community.element14.com/aggbug?PostID=21046&AppID=119&AppType=Weblog&ContentType=0" width="1" height="1">