/challenges-projects/design-challenges/smarter-life/b/blog/posts/fram-worksHello All, I hit a little stumbling block with the FRAM. I added a small delay ( CyDelay(10) ) to my UART printing code, and things worked better after that. I ran a simple unit test in which I wrote the entire contents of the FRAM with an ...en-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/smarter-life/b/blog/posts/fram-worksTue, 26 Nov 2013 21:28:51 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:7a4bcbcc-4451-405d-bb05-dda47e6ff8a9vsluiter0<p>Hi Alex,</p><p>&nbsp;</p><p>Congratulations! Most of the times those plots are easier to interpret correctly if you deduct the expected slope from them; you should see a constant value. If you&#39;ve missed a sample or two, you wouldn&#39;t be able to spot it on this scale, where a jump in difference between expected / measured is very clear.</p><img src="https://community.element14.com/aggbug?PostID=16573&AppID=105&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/challenges-projects/design-challenges/smarter-life/b/blog/posts/fram-worksThu, 21 Nov 2013 04:25:56 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:7a4bcbcc-4451-405d-bb05-dda47e6ff8a9e14 Contributor0<p>On a side note, how do we go about developing our PCB prototypes? Is that part of the Newark funding?</p><img src="https://community.element14.com/aggbug?PostID=16573&AppID=105&AppType=Weblog&ContentType=0" width="1" height="1">