EasyConfigure - Electrolube PU Resin

RE: EasyConfigure - Electrolube PU Resin

mcb1 — Fri, 08 May 2015 15:01:24 GMT

Excellent review.

Shame it didn't work for you.

As you said it is usually poured over the components to prevent damage from movement, and with smd this is as necessary.

Mark

RE: EasyConfigure - Electrolube PU Resin

shabaz — Fri, 08 May 2015 13:46:36 GMT

Hi Dragan,

Not bad at all for a first attempt!

I've tried resin casting in the past too, and had worse (DEFCON-1 level) disasters, like leaky molds : )

I don't have an optimum solution for it yet either. Good to see the resin is water-thin for detail as you show in your photo, I'd like to try it sometime (I've used some alternate product in the past). How long was the cure time?

RE: EasyConfigure - Electrolube PU Resin

ravi_butani — Fri, 08 May 2015 10:55:41 GMT

I need to check expiry date of mine electrolube resin too....