RE: Under Pressure - BLOG# 6 - BPM Uno - Experimenting with the LSM6DSL CLICK

taifur — Sat, 12 Nov 2022 16:34:48 GMT

The LSM6DSL is configured for SPI by default. I used the same library you used and I was able to get it working after some modification of the example code. You can check my blog here: [mention:6cfb04af4e974ba485b848ef734e5b4e:f7d226abd59f475c9d224a79e3f0ec07]

For I2C you need to set the jumper according to the following table:

Note the marking on the click board.

You just need to desolder 4 0ohm resistors (inside the red box) from the left and resolder those on the right. Mode is already configured as Mode 1. So, you don't need to change those jumpers.

RE: Under Pressure - BLOG# 6 - BPM Uno - Experimenting with the LSM6DSL CLICK

dougw — Sat, 12 Nov 2022 00:37:03 GMT

Usually you can disconnect a solder bridge simply by dragging a soldering iron between the bridged pads or use any solder removal method you have available. To make a solder bridge connection, just add solder to both pads until the solder joins together in a bridge.