/challenges-projects/design-challenges/wireless-power-ii/b/blog/posts/07-wireless-charging-of-dermatology-device-skimagerPrevious blog entry: 06 Ordering parts from Farnell / Element 14 Next blog entry: 08 Short introduction to dermatology and dermatoscopy using multispectral imaging RX coil miniaturisation to fit the &quot;SkImager&quot; dermatology deviceI used dremel to cut dowen-USTelligent Community 12https://community.element14.com/challenges-projects/design-challenges/wireless-power-ii/b/blog/posts/07-wireless-charging-of-dermatology-device-skimagerFri, 27 Jun 2014 23:57:37 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:c499f6e0-1a61-42b2-a917-11080782f548mcb11<p>Janis</p><p>I missed this earlier.</p><p>Your solution of the add-on at the bottom is a very clever idea to retrofit equipment.</p><p>&nbsp;</p><p>You&#39;ve managed to reduce the footprint very well, and I&#39;d like to be able to use your receiver design if I may for another project.</p><p>&nbsp;</p><p>When you 3D printed the bottom, did you use ABS or PLA ?</p><p>&nbsp;</p><p>Cheers</p><p>Mark</p><img src="https://community.element14.com/aggbug?PostID=17935&AppID=115&AppType=Weblog&ContentType=0" width="1" height="1">