Make Your Own Raspberry Pi Cell Phone
element14 Presents | DJ Harrigan's VCP Profile | Project Videos
Have you ever wanted to make your very own, custom cell phone? Do you love Linux and wish your phone was more open source? Today, we’re going to see how to make a working prototype cell phone using a Raspberry Pi, an Arduino compatible board, and a GSM module packed into a custom 3D printed case. |
| Product Name | Manufacturer | Quantity | Buy Kit |
|---|---|---|---|
RPI3-MODBP - Single Board Computer, Raspberry Pi 3 Model B+, BCM2837B0 SoC, IoT, PoE Enabled | RASPBERRY-PI | 1 | Buy Now |
Speaker Receiver 1 W 8 ohm 86 dB 0 Hz to 20 kHz | MULTICOMP | 1 | Buy Now |
| Microphone Omnidirectional 100 Hz to 16 kHz 2 V to 10 V-40 dB | MULTICOMP | 1 | Buy Now |
| 1991 - Antenna, Quad Band, Slim Sticker Type GSM/Cellular, 3dBi uFL | ADAFRUIT | 1 | Buy Now |
| Slide Switch SPST 46200R Series 3 A 125 V | SWITCHCRAFT/CONXALL | 2 | Buy Now |
Top Comments
Nice build.
You did a good job of presenting your components and explained why you need that configuration.
The case design was well explained and the demo was a good introduction into the capabilities.
…Thank you Sean!
There's a singular Python program running on the Pi, and a small Arduino sketch on the Fona Feather board.
Thanks DAB!
I'm glad all of that came through. I could have gone on for an hour talking more about the components...
-
DAB
-
Cancel
-
Up
+4
Down
-
-
Reply
-
More
-
Cancel
-
mrvolt
in reply to DAB
-
Cancel
-
Up
+3
Down
-
-
Reply
-
More
-
Cancel
Comment-
mrvolt
in reply to DAB
-
Cancel
-
Up
+3
Down
-
-
Reply
-
More
-
Cancel
Children