/challenges-projects/project14/solarpowerdevices/b/blog/posts/solar-spec---challenge-finaleWe&#39;re at the last day of the Heat is On Challenge. Here is the initial block diagram of my project: I&#39;ve implemented all of the hardware elements with the exception of only implementing a single temperature sensor and changing the sensor type to ...en-USTelligent Community 12https://community.element14.com/challenges-projects/project14/solarpowerdevices/b/blog/posts/solar-spec---challenge-finaleFri, 14 Sep 2018 22:56:39 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:3e49d5bf-f088-4a55-8199-c7840eed39d3jw07520<p>Hi Ralph,</p><p>I enjoyed following your project. You may find that the proper coating on the plastic PLA will block the uV light and extend the life of your printed case. I too hope you will followup so we can see the continuation of your project.</p><p>John</p><img src="https://community.element14.com/aggbug?PostID=5504&AppID=210&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/challenges-projects/project14/solarpowerdevices/b/blog/posts/solar-spec---challenge-finaleFri, 14 Sep 2018 22:41:39 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:3e49d5bf-f088-4a55-8199-c7840eed39d3genebren0<p>Well done!&nbsp; This was an interesting project.&nbsp; Hopefully the data will be helpful to you enabling you to get the most out of your solar array.&nbsp; It will be interesting to follow along with your enhancements as you go forward.</p><p>&nbsp;</p><p>Gene</p><img src="https://community.element14.com/aggbug?PostID=5504&AppID=210&AppType=Weblog&ContentType=0" width="1" height="1">