/learn/events/b/blog/posts/webinar-briefing-faq-arty-s7-workshop-part-2-building-a-custom-microcontroller-in-minutes-is-available-on-demandBuy Now Buy Now Buy Now Buy NowThe following workshop is now available for On-Demand Viewing: Arty-S7 Workshop: Part 2: Building a Custom Microcontroller in Minutes In this seminar series, we’ll explore how Xilinx FPGAs and SoC’s mitigate common cha.en-USTelligent Community 12https://community.element14.com/learn/events/b/blog/posts/webinar-briefing-faq-arty-s7-workshop-part-2-building-a-custom-microcontroller-in-minutes-is-available-on-demandSun, 25 Oct 2020 19:33:56 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:a61a095d-286d-4eb8-84ca-e3e540318699parasquid0<blockquote class="jive-quote">We have just overwritten the pre-installed firmware.&nbsp; How can we restore the original code?</blockquote><p>I have the opposite question. After going through Lab2 and successfully building and running the Hello World application on the microblaze, I realized that unplugging and then plugging back in the Arty causes it to revert to the pre-installed configuration.</p><p>&nbsp;</p><p>How do I make it so my design becomes &quot;permanent&quot; in the fpga? Is there some flash memory I need to write to for saving my hardware definition?</p><img src="https://community.element14.com/aggbug?PostID=10113&AppID=72&AppType=Weblog&ContentType=0" width="1" height="1">