Understanding and Developing with PSoC® 5LP and PSoC Creator

re: Understanding and Developing with PSoC® 5LP and PSoC Creator by clem57

clem57 — Fri, 03 Apr 2015 21:55:56 GMT

This was a very good webinar for the PSoC 5LP and Creator. In fact I would like to see again since they went fast in some places. Thanks guys!

Clem

re: Understanding and Developing with PSoC® 5LP and PSoC Creator by DAB

DAB — Fri, 03 Apr 2015 21:59:13 GMT

I agree with Clem.

The Cypress support software is very awesome and this new board is very capable with digital and analog programmable components.

Can't wait to get my hands on one.

DAB

re: Understanding and Developing with PSoC® 5LP and PSoC Creator by jjiricek

jjiricek — Sat, 04 Apr 2015 07:33:37 GMT

Unfortunatelly I missed the webinar. Is there a recording available for replay, please?

re: Understanding and Developing with PSoC® 5LP and PSoC Creator by fvan

fvan — Fri, 10 Apr 2015 18:54:56 GMT

Just watched the video (Understanding and Developing with PSoC 5LP and PSoC Creator).

Very well explained! I liked how most of it was hands-on, started with the basics and gradually moved to more complex actions.

Thank you for setting up this webinar.

re: Understanding and Developing with PSoC® 5LP and PSoC Creator by e14 Contributor

e14 Contributor — Tue, 14 Apr 2015 15:48:34 GMT

In case you missed it... the Webinar is now available here :

http://www.element14.com/community/videos/15872/l/understanding-and-developing-with-psoc-5lp-and-psoc-creator

re: Understanding and Developing with PSoC® 5LP and PSoC Creator by Ekta

Ekta — Sun, 16 Oct 2022 13:45:33 GMT

How to display sensor data in to TFT LCD DISPLAY?---Add in to the attached code? [closed]

int analogPin = A3;
int Rawval ; // variable to store the value read
int Scaleval ;
int RELAY_pin = 10; // Relay is connected to pin D10
void setup()
{
Serial.begin(9600); // setup serial
pinMode(RELAY_pin, OUTPUT);
}

void loop()
{
int Rawval = analogRead(analogPin);
Serial.print("Rawvalue from Analog input =");
Serial.print(Rawval);
// For 3V3 input to read 100%, 3V3 of 5V ref = (3.3 / 5) * 1023 = 675
Scaleval = map(Rawval, 0, 675, 0, 20);
Serial.print(" Scaled Value =");
Serial.println(Scaleval);

/// === RELAY code ===
// raw value 675 correspond to 20%, so for 5% we will get 169
if ( Rawval < 169) digitalWrite(RELAY_pin, HIGH);
else digitalWrite(RELAY_pin, LOW);
}