All cleaned up and nowhere to go.../members-area/personalblogs/b/blog/posts/all-cleaned-up-and-nowhere-to-goSimple holding place for the code to this point. Sort of a version management system if you think about it .I have tested the code here, and it does compile, and it does run on a 328P Arduino Nano (programmed with the 6pin programmer).The code turns en-USTelligent Community 12RE: All cleaned up and nowhere to go...https://community.element14.com/members-area/personalblogs/b/blog/posts/all-cleaned-up-and-nowhere-to-goThu, 17 Mar 2016 00:11:14 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:ec05106f-eba4-49d9-8c59-721fd34a07adclem571<p>I like what you have done <span class="j-username-wrap"> <span>[mention:057cebb0fa1346ed87ac65e97e5bad60:e9ed411860ed4f2ba0265705b8793d05]</span>&nbsp; Not sure what is next, but I can not wait too long. <span>[View:/resized-image/__size/16x16/__key/commentfiles/f7d226abd59f475c9d224a79e3f0ec07-ec05106f-eba4-49d9-8c59-721fd34a07ad/contentimage_5F00_1.png:16:16]</span></span></p><p>Clem</p><img src="https://community.element14.com/aggbug?PostID=21599&AppID=293&AppType=Weblog&ContentType=0" width="1" height="1">RE: All cleaned up and nowhere to go...https://community.element14.com/members-area/personalblogs/b/blog/posts/all-cleaned-up-and-nowhere-to-goWed, 16 Mar 2016 19:37:28 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:ec05106f-eba4-49d9-8c59-721fd34a07adjack.chaney560<p>Code above provides a 57600 bps, n, 8, 1 serial through the USB. Commands to try...</p><p>*IDN?</p><p>&nbsp;&nbsp;&nbsp;&nbsp; will print the identifier information for the device.</p><p>CONF:TABL 1</p><p>FETC:TABL?</p><p>&nbsp;&nbsp;&nbsp;&nbsp; will print the content of table 1 which is an 8x1 array.&nbsp; Since the calibration is not programmed, the values are all -1, but it gives a view of what the output format will look like.</p><p>CONF:MONI 0,1,2,3,8,9,10</p><p>FETC:MONI?</p><p>&nbsp;&nbsp;&nbsp;&nbsp; will output the values of the first 4 A/Ds and since they are disabled by default should print 0 for the first 4 (A/D raw) and -1 for sensor values</p><p>&nbsp;</p><p>Should have included some examples before.&nbsp; Sorry,</p><p>&nbsp;</p><p>Jack</p><img src="https://community.element14.com/aggbug?PostID=21599&AppID=293&AppType=Weblog&ContentType=0" width="1" height="1">