/members-area/personalblogs/b/blog/posts/getting-started-with-the-cora-z7-board---a-step-by-step-guide-to-creating-a-sdk-projectA few weeks ago we looked at how we could create the hardware element of a Zynq design which uses the Cora Z7, in this blog we are going to look at how we can create the software application and run on the hardware.To do this we are going to use Xilien-USTelligent Community 12https://community.element14.com/members-area/personalblogs/b/blog/posts/getting-started-with-the-cora-z7-board---a-step-by-step-guide-to-creating-a-sdk-projectThu, 30 May 2019 02:33:52 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:5b728eca-50cf-4d8e-a233-e0fb4bbaf4ccgeof230<p>Hey Adam, thanks for the blogs on the Cora z7.</p><p>&nbsp;</p><p>Just wanted to point out -- you&#39;re writing 9 memory locations.</p><p>&nbsp;</p><p>However, I&#39;ve found your series of articles extremely helpful.&nbsp;&nbsp; I haven&#39;t done any hardware design since Xilinx ISE, so your step-by-step tutorials clearly demoed the key points in getting a hybrid design going that i needed. </p><p>&nbsp;</p><p>Cheers -- Geof</p><img src="https://community.element14.com/aggbug?PostID=5571&AppID=293&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/members-area/personalblogs/b/blog/posts/getting-started-with-the-cora-z7-board---a-step-by-step-guide-to-creating-a-sdk-projectMon, 10 Dec 2018 02:08:55 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:5b728eca-50cf-4d8e-a233-e0fb4bbaf4cccra80001<p>Very good gettings started Adam.</p><p>&nbsp;</p><p>Could You add one more , how To do a boot.bin for SDcard?</p><p>&nbsp;</p><p>Thanks a lot.</p><img src="https://community.element14.com/aggbug?PostID=5571&AppID=293&AppType=Weblog&ContentType=0" width="1" height="1">