/members-area/personalblogs/b/frank-milburn-s-blog/posts/ais-alarm---schematicProject Objective: Develop an open source AIS Alarm that alerts sailors that a new marine vessel with AIS is within range The breadboard prototyping and first pass at firmware are sufficient to proceed to hardware design. After exchanges w...en-USTelligent Community 12https://community.element14.com/members-area/personalblogs/b/frank-milburn-s-blog/posts/ais-alarm---schematicSat, 13 Jan 2018 00:46:52 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:840904e7-5fdd-4bf3-87e7-97e7df3c2154genebren1<p>Frank,</p><p>&nbsp;</p><p>I love those dual mosfet packages.&nbsp; The pinout is such that you can not place them on the board incorrectly, i.e. the pinout is symmetrical.&nbsp; Too bad you did not need the other half of the set.</p><p>Gene</p><img src="https://community.element14.com/aggbug?PostID=4107&AppID=328&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/members-area/personalblogs/b/frank-milburn-s-blog/posts/ais-alarm---schematicFri, 12 Jan 2018 08:39:33 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:840904e7-5fdd-4bf3-87e7-97e7df3c2154three-phase1<p>Nice clear well labelled schematic. Excellent to see you incorporating advice from previous posts, there are some amazing talented helpful people on here.</p><p>&nbsp;</p><p>Kind regards</p><img src="https://community.element14.com/aggbug?PostID=4107&AppID=328&AppType=Weblog&ContentType=0" width="1" height="1">