The Bill of Materials of the Lithium Battery Charger shield for Arduino

e14 Contributor — Fri, 08 Oct 2021 08:02:02 GMT

Current Revision posted to Documents by e14 Contributor on 10/8/2021 8:02:02 AM

The Bill of Materials of the Lithium Battery Charger shield is given below.

Quantity	Part Description	Designator
1	LT1510 Constant Current/Constant Voltage Battery Charger SO-16	U1
1	REF03 2.5V Voltage Reference SO8	U2
1	ACS712-5A Hall Effect Based Current Sensor 8-SOIC	U3
1	LM258 Low Noise Operational Amplifier SO-8	U4
1	5110 LCD Module	LCD1
2	SS14 1A 40V Schottky Rectifier SMA	D1 D2
1	1N4148 General Purpose Diode SOD80C	D5
3	BSS138 Mosfet SOT-23	Q1 Q2 Q3
1	Red LED 0805	D3
1	Green LED 0805	D4
1	220nF 50V 0805 X7R SMD Ceramic Capacitor	C1
5	100nF 50V 0805 X7R SMD Ceramic Capacitor	C4 C8 C9 C10 C11
2	1nF 50V 0805 X7R SMD Ceramic Capacitor	C6 C7
1	10uF 25V 1206 X7R SMD Ceramic Capacitor	C3
1	1uF 25V 1206 X7R SMD Ceramic Capacitor	C5
1	22uF 16V Tantalum Capacitor B-Case	C2
1	MSS1260-333 330uH Coilcraft Power Inductor	L1
3	100R 1% 0805 Resistor	R5 R6 R23
3	20K 1% 0805 Resistor	R7 R19 R22
2	1K 1% 0805 Resistor	R1 R10
1	70.6K 1% 0805 Resistor	R4
6	10K 1% 0805 Resistor	R11 R12 R13 R14 R20 R21
2	0805 Resistor Value Depends on the LEDs	R15 R16
1	3K8 1% 0805 Resistor	R24
3	100K 1% 0805 Resistor	R3 R17 R18
1	330R 1% 0805 Resistor	R9
1	300R 1% 0805 Resistor	R2
1	180K 1% 0805 Resistor	R8
4	Tact Push Button SMD	SW1 SW2 SW3 SW4
1	1×6 2.54mm pitch 15mm height Male Header	J2
2	1×8 2.54mm pitch 15mm height Male Header	J3 J4
1	1×10 2.54mm pitch 15mm height Male Header	J1
1	JST-PH Connector 2 Pin Right Angle	J5
1	1×2 5.2mm Pitch Screw Terminal Block	J6

Tags: lithium, battery, arduino, charger