Controlling AUBoard-15P form Matlab using the JTAG to AXI interface

Umallik 1 month ago

My project requires control of an AUBoard-15 from Matlab (using the Matlab generated JTAG to AXI block). To that end I am required to create a Board definition file using the interface provided in Matlab. Can someone help me with the entries requested below. I do not have access to the schematics. I am not sure how to go about coming up with answers to these questions.

Top Replies

iksevas 1 month ago in reply to iksevas +1

Take this for what it is worth from AI:

0 iksevas 1 month ago

There are only two options for JTAG on the AUBoard - the FPGA and the FMC connector. If you are not using the FMC connector, then the FPGA is the only device in the chain. As far as IR length of the FPGA, you more than likely need to dig into some datasheets for the Artix UltraScale+ and if you are using an FMC card, you will need to determine what devices on that card are in the JTAG chain and similarly find their IR length.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 iksevas 1 month ago in reply to iksevas

Take this for what it is worth from AI:
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Umallik 1 month ago in reply to iksevas

Thank you.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel