Actions
Forum Thread Details
  • State Not Answered
  • Replies 7 replies
  • Subscribers 361 subscribers
  • Views 537 views
  • Users 0 members are here
Related

Lab 1.3 not working at the final stage

Former Member

Hi all,
  
    Just began exploring the Zedboard. I am sure everybody has completed this . My Lab 1.3 fails at the last stage.

    Hit any key to stop autoboot:0
zed-boot> 

    after Hit any key to stop autoboot:0, I do not get the zed-boot>  prompt.

Instead I see a lot of message pertaining to the kernel code..( error / code crash ...)

    What are the files I need to have in the SD ram.

    I have the following:

    1. devicetree.dtb ( renamed factory file in SD card)
    2. boot.bin ( from lab 1.3 output in SD card)
    3. ramdisk32M.image.gz ( renamed factory file )
    4. ZImage ( from factory file in SD card )

    What did I do wrong ???

  Please help!!

Thank you

Parents
  • 0

    Hi Folks,

    I also had trouble in the final stage.
    My terminal didn't respond.
    The instruction in step 12, page 16, says power cycle the board. This causes Tera Term to looses the terminal connection. Instead Press BUTTON 7 u201CPS-RSTu201D in the bottom left corner of the board to warm-boot the board.
    Then the terminal starts responding with the uboot-prompt when you send keyboard chars to interupt the booting sequence.

    Just sharing it. Hope this helps.

    Rgds,
    Technicolor
    Just sharing

Reply
  • 0

    Hi Folks,

    I also had trouble in the final stage.
    My terminal didn't respond.
    The instruction in step 12, page 16, says power cycle the board. This causes Tera Term to looses the terminal connection. Instead Press BUTTON 7 u201CPS-RSTu201D in the bottom left corner of the board to warm-boot the board.
    Then the terminal starts responding with the uboot-prompt when you send keyboard chars to interupt the booting sequence.

    Just sharing it. Hope this helps.

    Rgds,
    Technicolor
    Just sharing

Children
No Data