1. PicoZed FMC Carrier Card V2 + PicoZed 7Z030 SOM
2. Digilent JTAG HS3 cable
Software used: Vivado 2020.1
I want to program the Programmable logic with bitstream via JTAG connection through Vivado. But I am getting an error message "No devices detected on target" on either trying to "auto-connect" or "open new target with different JTAG clock frequencies" option under "open hardware manager" in Vivado. Error message is shown in the snippet below.
Following are the jumper settings:
1. JP3 is closed in position 1-2
2. JP4 is closed
3. JP5 closed in the position 1-2
4. PicoZed SOM is set in JTAG boot mode
On turning on the power of the board, PG_MODULE(D4 LED), VIN_HDR(D5 LED) and D14 LED turns on (carrier board) and D3 LED turns on (PicoZed SOM). I have previously tried to perform SD boot which was successful and PS red LEDs flashed.
Could you please help me figure out what could be the issue?