Error SSH fw_setdevicetree devicetree_axilite.dtb

Hi everyone,

I am a student trying to launch Zedboard and the example led_blinking of MATLAB. I have instaled ISE 14.4 and 14.7 and i conected it in Matlab.

When I use HDL workflow, I have a problem in the 'Generate Software Interface Model' step

"Error executing SSH command: fw_setdevicetree devicetree_axilite.dtb"

I am a noob using Zedboard, what can i do to solve it?

0 mbrown over 8 years ago

Did you search on this forum? I think somebody solved this here -- http://zedboard.org/content/execute-model-target

/Matt
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 8 years ago

Hello,
I also encountered the same problem. I followed the link that Matt sent, and uninstalled ISE 14.4, leaving only 14.7. I'm not sure what they meant by 're-configuring Matlab, ISE and Zedboard target', but when I ran it, it still does not work for me.

Is anybody able to solve this problem?
Regards,
nobitanobi
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mbrown over 8 years ago

Did you return to steps 1-5 of this tutorial to configure everything?
http://www.mathworks.com/help/hdlcoder/examples/getting-started-with-hardware-software-codesign-workflow-for-xilinx-zynq-platform.html?s_tid=srchtitle

/Matt
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 rabei.shwehdi over 8 years ago

hi i have same problem ... what is the solution ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 jafoste4 over 8 years ago

Hello Rabei.shwehdi,
Did you follow the steps that Matt suggested above? If so, what exactly are you having an issue with? More details would be appreciated.
--Josh
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 rabei.shwehdi over 8 years ago

hi
i ma trying to make matlab (hdlcoder_led_blinking) example work all steps ok .
but when i start to generate software interface model i got this massage
Failed Error executing SSH command: fw_setdevicetree devicetree_axilite.dtb
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 jafoste4 over 8 years ago

Hello Rabei,
Have you taken a look at this link?
http://zedboard.org/content/execute-model-target
Also have you completed steps 1-5 from this tutorial to reconfiugre everything?
http://www.mathworks.com/help/hdlcoder/examples/getting-started-with-hardware-software-codesign-workflow-for-xilinx-zynq-platform.html?s_tid=srchtitle
--Josh
--Josh
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 rabei.shwehdi over 8 years ago

I forgot to configure the sd card using( targetupdater)..

now ok
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel