I am trying to get the VxWorks image on U boot for the ZUB1CG board, but I am getting the below error again and again.
Unknown exception
Exception Syndrome Register(ESR): 0x02000000
Exception Address: 0xffffffff802a8218
Process State Register(PSTATE): 0x00000044
Task: 0xffffffff80997000 "tRootTask"
0xffffffff80997000 (tRootTask): task 0xffffffff80997000 has had a failure and has been stopped.
0xffffffff80997000 (tRootTask): The task has been terminated because it triggered an exception that raised signal 4.
I am sure that there is some issue with the memory component of the kernel file, as I do not have the correct address and size. Please let me know these two things.
\sh memory
The memory node describes the physical memory layout for the system. The
Ranges are specified in the <reg> property.
This node must specify the below properties:
\is
\i <reg>
This property consists of address and size pairs that specify the physical
address and size of the memory ranges.
\i <device_type>
This property describes the device type. It must be "memory.".
\ie
An example of the device node is shown below:
\cs
memory
{
device_type = "memory";
reg = <0x0 0x00000000 0x0 0x78000000>;
};
\ce
I need Similar for ZUB1CG Board.
