Highlite of connected points in router does not work

Question

Hi guys,

When trying to route a board manually I don't see the highlite of the opposite connected point anymore. Did I switch this off by accident? I mean the behavior on this video:

Routing Signal Trace on Eagle PCB Layout

Reagrds,

Mischa

autodeskguest · Accepted Answer

I suspect you are using the WIRE tool to route with instead of the ROUTE tool. A Wire will not snap to the pad and pick up the signal name and thus will not highlight the airwire or destination pads. HTH Warren -- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.