Ask our expert a question on Inductive components including ferrites, ferrite beads, inductors, common-mode chokes, transformers, and connectors

This thread has been closed to new questions.

However, we welcome you to Post Your Question about Power Management in the element14 Community Power Management group. You'll find many fellow members and experts who have just the answer you're looking to find!

Thank You, Your Friends at element14 Community

0 lfa555 over 15 years ago

Hi Lorandt,

do you also have wireless LAN and BT cables?

We have an urgent need of them
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 15 years ago in reply to lfa555

Because all this application are WIRELESS make no sense to use a cable ;-)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 14 years ago

Sorry to bother you but I can't find any forms to post my questions on. So if you or anyone can show me the direction of where to go.. What I'm trying to build is a (RF) digital band-pass filter. I can't find any schematic's all I could find was equations to find resident freq.. What I'm trying to build is a device that you put in a number between 100Mhz and 800Mhz or so. That you can very lower and upper number digitally.

Any help would be appreciated,
Rob
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 14 years ago

Hey Lorandt ....could you please help me to build my SMPS charger circuit for DC output 120-150 volts @10 ampers
which topology of smps charger should i use...
should i make the use of SG 3525 pwm controller or microcontroller for PWM generation !!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 14 years ago in reply to Former Member

Hello Ashish Srivastav, I am verry sorry but such power is out of our limits. We do not have any transformer or chokes which could handle such power right now. Our high current version inductors do not exceed 20~30µH and I guess this would not fit to your request. Our High Voltage inductors do not get over few hundert mA. This request is too special and can't be done using standard products. Did you try at TI or LT if they have a solution for the controller?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 12 years ago

Im thinking of using an LM2596 switching power supply. It outputs 3 amps. Would using this to charge an ipod be bad. Because an ipod charges with 1 amp. So would the ipod only take 1 amp, or take the full 3 amps and blow the battery?

This thread has been closed to new questions.
However, we welcome you to Post Your Question about Power Management in the element14 Community Power Management group. You'll find many fellow members and experts who have just the answer you're looking to find!

Thank You, Your Friends at element14 Community
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel