I have been gifted an Ender 3 Pro for my art department. I’m completely new to 3D printing so having to learn from scratch, so please bear with me.
I tried one print and had some success but the first layer was a little rough. But every print since then hasn’t stuck to the plate. It will outline initially but then it starts pulling up. I read about levelling the bed so I have done this, then I also tried to upping the temperature of the first layer to see if it helped stick. But no joy. I seem to get an outline which lifts and then when it goes to print it clogs/ lifts and never settles. I’ve tried increasing/ decreasing the gap. But it doesn’t seem to help. Any advice would be really appreciated as I’m just stuck and frustrated! Thank you!