RE: Kria KV260 - 01- Starting with the Smart Camera Firmware

abdul.rahman — Fri, 19 May 2023 15:05:53 GMT

I have followed the exact same steps and I have AR1335 IAS Camera Module mounted on the Kria kv260 board though MIPI CSI-2 interface (J7 Port). When I run the application, I don't get any output on my display. I have connected my display through HDMI port on the board and the Ethernet through the ethernet port. When I use Webcam, it does show output. Kindly tell me if there is something other than the above mentioned steps needed for being able to get output from MIPI camera?

Furthermore when I run the following command to install the application, some packages could not install.

sudo dnf install packagegroup-kv260-smartcam

Following is the list of packages that could not be installed:

accelize-2021_1-all
accelize-2021_1-any
accelize-2021_1-noarch
accelize-2021_1-aarch64
accelize-2021_1-armv8a
accelize-2021_1-armv8a_crc
accelize-2021_1-cortexa72_cortexa53
accelize-2021_1-zynqmp
accelize-2021_1-zynqmp_ev
accelize-2021_1-k26
accelize-2021_1-k26_kv
accelize-2021_1-zynqmp_generic

Could these be the root of the problem?

RE: Kria KV260 - 01- Starting with the Smart Camera Firmware

javagoza — Sat, 30 Apr 2022 09:12:58 GMT

After many problems with my Windows 10 computer and a very slow ADSL Internet connection, I finally managed to present a functional project for my kitchen appliance monitor.

Whoever is interested can see it on hackster.io

https://www.hackster.io/javagoza/kria-kitchen-ml-lifeguard-d038f7