Build a project with the Arty S7 - Line Follower Robot (Part 2) - Setting up Vivado 2019.2 and Demo program/technologies/fpga-group/b/blog/posts/build-a-project-with-the-arty-s7---line-follower-robot-part-2---setting-up-vivado-2019-2-and-demo-program-1504169782A quick update on the hardware issue. I tried powering the board and it didn&#39;t power up. It turns out the hardware had a short-circuit in production. Short in R220 and R217 had resulted in the failure of a 3.3V supply to the board which was removed. en-USTelligent Community 12RE: Build a project with the Arty S7 - Line Follower Robot (Part 2) - Setting up Vivado 2019.2 and Demo programhttps://community.element14.com/technologies/fpga-group/b/blog/posts/build-a-project-with-the-arty-s7---line-follower-robot-part-2---setting-up-vivado-2019-2-and-demo-program-1504169782Thu, 28 Jul 2022 06:43:15 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:a7b573c8-1805-48a8-923a-57b4b89fa853javagoza1<p>I&#39;m glad you were able to fix your board. My board also has the AD2384 regulator burned out, I couldn&#39;t locate why it melted, it&#39;s connecting it and starting to smell burnt, some short circuit somewhere.<br />Has the repair been very difficult for you? I have hardly any experience desoldering such small components, I almost always end up destroying everything around it. Any advice from your experience?</p><img src="https://community.element14.com/aggbug?PostID=24063&AppID=19&AppType=Weblog&ContentType=0" width="1" height="1">