/technologies/fpga-group/b/blog/posts/booting-up-ultrazed-eg-dev-boardHello all, I am not able to boot up the board even after following the steps exactly given in the manual. It seems that the board is not drawing any current as the fan which I am mounting on it is also not powering up and the PS red LED is also not gen-USTelligent Community 12https://community.element14.com/technologies/fpga-group/b/blog/posts/booting-up-ultrazed-eg-dev-boardMon, 07 Nov 2022 18:29:33 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:59f6fe6c-d850-4314-8f44-6ac5b4ff4399flyingbean0<p>Check the booting mode configuration: DIP setting as below</p> <p><img src="/resized-image/__size/1280x720/__key/commentfiles/f7d226abd59f475c9d224a79e3f0ec07-59f6fe6c-d850-4314-8f44-6ac5b4ff4399/pastedimage1667845654510v1.png" alt=" " /></p> <p></p> <p>I used a carrier board with Ultrazed-EG before. So please read the hardware user guide for your trouble-shooting:</p> <p><a href="https://www.avnet.com/wps/wcm/connect/onesite/4f81c10d-aca8-4ccc-942a-2b07d1b8fcf0/5264-UG-AES-ZU3EGES-1-SOM-G-v1-1-V1.pdf?MOD=AJPERES&amp;CACHEID=ROOTWORKSPACE.Z18_NA5A1I41L0ICD0ABNDMDDG0000-4f81c10d-aca8-4ccc-942a-2b07d1b8fcf0-obVY6kd">https://www.avnet.com/wps/wcm/connect/onesite/4f81c10d-aca8-4ccc-942a-2b07d1b8fcf0/5264-UG-AES-ZU3EGES-1-SOM-G-v1-1-V1.pdf?MOD=AJPERES&amp;CACHEID=ROOTWORKSPACE.Z18_NA5A1I41L0ICD0ABNDMDDG0000-4f81c10d-aca8-4ccc-942a-2b07d1b8fcf0-obVY6kd</a></p> <p></p> <p>Good luck!</p><img src="https://community.element14.com/aggbug?PostID=24701&AppID=19&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/technologies/fpga-group/b/blog/posts/booting-up-ultrazed-eg-dev-boardTue, 01 Nov 2022 14:48:39 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:59f6fe6c-d850-4314-8f44-6ac5b4ff4399rsjawale241<p>I would suggest to use a digital multimeter to check if the board is getting the supply or not. Maybe some power supply IC has failed or shorted. You can identify the power supply area on the PCB by inspection method. Just follow the path from the power input side. First check the voltage at the power input.&nbsp;</p><img src="https://community.element14.com/aggbug?PostID=24701&AppID=19&AppType=Weblog&ContentType=0" width="1" height="1">