/technologies/motors-and-drives/b/clem-s-cnc-control-project/posts/the-community-has-spoken-the-wonders-of-open-source-hardwareThe community has spoken.In the last Blog post I&#39;ve asked you about the positioning of the electronics cabinet. And by far the most popular choice was to put it above the whole machine where no splinter, chip or Dash of coolant can go.So i took that en-USTelligent Community 12https://community.element14.com/technologies/motors-and-drives/b/clem-s-cnc-control-project/posts/the-community-has-spoken-the-wonders-of-open-source-hardwareTue, 22 Nov 2022 14:28:28 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:f0198117-fc84-4f5b-84a7-e5092e319fc8dougw1<p>The safety cutoff should be conveniently accessible. If you put it on the box, it might be worth adding an extra connector so you can add an external switch in a more convenient location once you have figured out your workflow.</p><img src="https://community.element14.com/aggbug?PostID=24832&AppID=391&AppType=Weblog&ContentType=0" width="1" height="1">https://community.element14.com/technologies/motors-and-drives/b/clem-s-cnc-control-project/posts/the-community-has-spoken-the-wonders-of-open-source-hardwareTue, 22 Nov 2022 09:27:03 GMT93d5dcb4-84c2-446f-b2cb-99731719e767:f0198117-fc84-4f5b-84a7-e5092e319fc8mayermakes0<p>here is my fork of the duet2 hardware breakout: <a id="" href="https://github.com/mayermakes/Duet-2-Hardware">https://github.com/mayermakes/Duet-2-Hardware</a></p><img src="https://community.element14.com/aggbug?PostID=24832&AppID=391&AppType=Weblog&ContentType=0" width="1" height="1">