Programming help

Question

I need to write a program to do the following with Arduino: a. turn on the red light for 1 second b. turn off the red light c. turn on the blue light for 2 seconds d. turn off the blue light e. repeat

topper727 · Accepted Answer

} void loop(){ digitalWrite(11,LOW); delay(1000); digitalWrite(12,HIGH); digitalWrite(11,LOW); delay(2000); digitalWrite(12,HIGH); delay(500); }

clem57 · Answer

Learning to Program the Arduino | Linux Journal Good place to learn how and where to get more help. Clem

mcb1 · Answer

Is this for a test, homework or just for your own experimentation. The task is not hard, and there are plenty of resources within the internet. It is always better that you learn and understand how to do something, because usually the task gets more complicated later. Since you haven't included any code, or where you got stuck, I'm assumming you haven't tried doing it your self. Mark

mconners · Answer

Maybe that was his intent. To give code with a slight bug, so the OP would have to debug it and learn a little. Mike well, other than the delay of death. Mike

mconners · Answer

Also, the OP may have marked it correct cause it was the first answer to give code, albeit buggy, and didn't tell them to crack a book Mike

Programming help

Top Replies