I have a bad LED 3 digit display and i have not been able to find one with the proper terminals to replace it with. The issue is all the ones i have found dont have the gap on the five pin side. Here is the info I have.
Over all display: 13.5mm X 22mm X 6mm (tall)
Digits: 7mm X 4mm
Pins: .5mm
Pin spacing (from pin center to pin center): 2.5mm
Display color: Red
On the side it says:
A303E-CL G/W
S0826 04 RoHS P
The display and digit size can fluctuate a little but the pins need to be the same as its for a pre-manufactured board.
If it maters its out of an Autometer Pro-Comp Ultra-Lite wideband air/fuel gauge.
Attachments:
 | |
 |
