Episode 116 Project Files

benheck

17 Jan 2014

Laser-cut cap end for the reflow oven, and Arduino Uno files to drive the circuit.

Attachments:

116_files.zip

Top Comments

Former Member over 11 years ago +1

I adore your show sooooooooo much I realy hope I win the ouya!!!!!!!!!!!!!!!!!!!!!

Parents

Former Member over 9 years ago

Has anyone built one yet ???Oh is there a schematic for this build ???
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
swampyank1 over 9 years ago in reply to Former Member

Hello Jay;
I have built one, and made work, but have not use it on a board as of yet..
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
Former Member over 9 years ago in reply to swampyank1

Oh ok cause I have 2 toaster waiting and I was looking to use the Ben heck design but I am new to using arduino and programming ..
But I though about using a Teensy v3.2 to make mods to have it work on 3.3v..
What kind of avr chip or board did you and ben heck use??

Thanks
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
swampyank1 over 9 years ago in reply to swampyank1

I use Arduino Uno and the software was easy to understand for the set and wire.
Also bough adafruit components as they call out in the video, everything went together very will, with no problems.

Only thing make sure to read the software cardfully, the pins out are not the same as the Uno...
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
luciusjo over 9 years ago in reply to swampyank1

Were there any issues with the code? I bough the components as well, but for some reason my buttons dont work to move through the menu. I checked them with another program and the work, and Im trying to do it with only 1 thermocouple (corrected the code for this)
Any suggestions?

Thank you,
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel

Comment

luciusjo over 9 years ago in reply to swampyank1

Were there any issues with the code? I bough the components as well, but for some reason my buttons dont work to move through the menu. I checked them with another program and the work, and Im trying to do it with only 1 thermocouple (corrected the code for this)
Any suggestions?

Thank you,
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel

Children

No Data