How possible is it to make a wireless 360 controller into a wired one for use on PC?

Just like the title says, would it be possible to make a wireless 360 controller into a wired controller for use on a pc? I'm tired of getting the charge packs that just stop charging after a while or after they get glitched up.

Thanks

Top Replies

elevatorguy over 11 years ago +1

The hard way: If you are comfortable with soldering and like to take the controller apart, then it is possible, for example, to open up the controller, solder wires from buttons, trigger and joystick potentiometers…

Parents

0 Former Member over 11 years ago

It would be very hard unless there is already a USB controller in there that is either not connected to anything or connected to the wirless module. If there is you would be able to just wire it to USB, but without looking in the controller there is no way to tell if that is the case, and it would have to be clearly labled, which is extremely unlikely.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Former Member over 11 years ago

It would be very hard unless there is already a USB controller in there that is either not connected to anything or connected to the wirless module. If there is you would be able to just wire it to USB, but without looking in the controller there is no way to tell if that is the case, and it would have to be clearly labled, which is extremely unlikely.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Former Member over 11 years ago in reply to Former Member

Well, that's why I'm posting here. Maybe Ben can figure it out. I have plenty of charge cables that I wouldn't mind repurposing to make a wired controller out of a wireless one.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel