VCP Biography: DJ

DJ is a designer and maker based out of Southern California. Inspired by countless gadgets and inventions shown in T.V. and films, he's always been inspired to bring that kind of fantastical technology to life. In the past he's put his skills to use creating puzzles for escape rooms, building gadgets and writing tutorials for Instructables.com, prototyping hardware for SLA 3D printers, and teaching many people how to solder and use CNC lasers. He currently works as an instructor at a local makerspace where he shares his passion for digital design and open source hardware. In his spare time, he runs his personal YouTube channel: Mr. Volt, where he builds custom gadgets and 3D-printed props.

Featured Videos/Projects:

DJ's Videos:

See all of DJ's element14 presents Episodes

Parents

Chris4973 over 2 years ago

HI
I saw the project signed 368 the thread cutter I'm trying to make the project. for now I'm in the embryonic stage of the project I installed the software on Arduino but I can't enable the zero point adjustment function, I can enter the quantity and all the cutting measures but when I go to run the cut starts. while when I start arduino the writing awcs ready appears to me and if I don't bring the sensor close to the magnet it doesn't go further. Can you help me figure out what's wrong?
Thank you

Comment

Chris4973 over 2 years ago

HI
I saw the project signed 368 the thread cutter I'm trying to make the project. for now I'm in the embryonic stage of the project I installed the software on Arduino but I can't enable the zero point adjustment function, I can enter the quantity and all the cutting measures but when I go to run the cut starts. while when I start arduino the writing awcs ready appears to me and if I don't bring the sensor close to the magnet it doesn't go further. Can you help me figure out what's wrong?
Thank you

Children

No Data