"Remember me always!" - Part 002

COMPACT

5 Aug 2014

An Alternative Universe

When doing some research I found the EnOcean Sensor Kit Manual.

It describes a method to prepare a RPi to get FHEM with EnOcean Sensors up and going.
Very Useful Stuff!

http://www.farnell.com/datasheets/1824742.pdf

Top Comments

electronichamsters over 11 years ago in reply to vish +1

Hi Vish, I think this is the procedure: 1) save the addon for enocean binding in the ~/addons folder 2) configure the enOcean binding ~/configurations/openhab.cfg, but look at what others have said about…
jpc over 11 years ago in reply to vish +1

Check out some of the other forget_me_not blog entries here on element14 for getting this up and running (on a Pi) if you get stuck. There are a couple of little trouble causing things that have been covered…

ipv1 over 11 years ago in reply to vish

Maybe I am too late, but a bunch of of did various posts on how to use the enocean bindings.
Hope they help.
Cheers
IP
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
jpc over 11 years ago in reply to vish

Check out some of the other forget_me_not blog entries here on element14 for getting this up and running (on a Pi) if you get stuck. There are a couple of little trouble causing things that have been covered and resolved. You need to disable use of /dev/ttyAMA0 in /boot/cmdline.txt and /etc/inittab so that the EnOcean Pi can use it and you need to modify a line in start.sh to allow java to access symbolically linked com ports, such as /dev/ttyAMA0
- Cancel
- Vote Up +1 Vote Down
- Sign in to reply
- More
- Cancel
electronichamsters over 11 years ago in reply to vish

Hi Vish,
I think this is the procedure:

1) save the addon for enocean binding in the ~/addons folder
2) configure the enOcean binding ~/configurations/openhab.cfg, but look at what others have said about changes to serial port
3) add the item to your /configurations/items/demo.items file per wiki:
Switch Button_Up () {enocean="{id=00:00:00:00, eep=F6:02:01, channel=B, parameter=I}"}
Number UG_Flur_Temp "Temperature [%.1f °C]" <temperature> () {enocean="{id=00:00:00:00, eep=A5:02:05, parameter=TEMPERATURE}"}
4) Add these items to the sitemap under /configurations/sitemaps/demo.sitemap
- Cancel
- Vote Up +1 Vote Down
- Sign in to reply
- More
- Cancel
vish over 11 years ago

Anybody found any documents describing how to connect enocean with openHAB? I am still searching.
I found only this page so far : https://github.com/openhab/openhab/wiki/EnOcean-Binding
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
electronichamsters over 11 years ago

Good find. Thanks for posting
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel