Most clever, most useful, most indispensable...
How many of these tools do you have?
What other tools should be in this list?
Most clever, most useful, most indispensable...
How many of these tools do you have?
What other tools should be in this list?
The driver fits into a 11mm socket HOWEVER... none of them will work as the base of the drivers all spin.
You could perhaps market that as a 'torque limiter' design feature though...
If I were to do this for real, I would use a 2" extension drilled axially. Chop off the spinning end and insert the driver into the drilled hole. Tap lightly with the wire fed welder and file for aesthetics.
Alternatively could turn it into an impact socket 'pin drive' type coupling by drilling a hole perpendicular to the shaft to allow you to drop a pin through both it and the existing Tommy Bar hole in the driver. Turn a groove in the shaft over the hole to locate your rubber O-ring to hold the pin in place.
Allows you to quick-change the nut driver after shearing its end off every time you use it. 
