Personal Blogs

Legacy Personal Blogs Entrepreneur

Group Actions

Engagement

Author Author: manikandan341
Date Created: 6 Jun 2019 8:47 AM Date Created
Views 1940 views
Likes 4 likes
Comments 14 comments

Related

Recommended

Entrepreneur

6 Jun 2019

Can any one guide me to be entrepreneur...?

Top Comments

dougw over 6 years ago +7

Becoming an entrepreneur is easy, just try to take something to market. Becoming a successful entrepreneur is a different story. Almost all successful entrepreneurs have failed in the past, but are driven…
Fred27 over 6 years ago +6

Try things. Be prepared to fail, because at times you will. In fact "fail fast" is a good tip. If you're project is not going to be a success for whatever reason, its good to know this early before spending…
shabaz over 6 years ago in reply to manikandan341 +5

Hi Manikandan, It depends which one, and how much info (and time is really short, so ping-ponging like this isn't a way I can work : ( If you spend a few minutes looking through this link: How to Ask Questions…

Parents

manikandan341 over 6 years ago

well i joined a small scale embedded systems industry...and i need to clear some doubts...
How to use i2c concept in cube suit plus(This is developed by renesas controller industry) with code generator....please any one tell me that steps to code generates for i2c...And another one how can i get live gps data per second using sim868...now it's take minimum 5 seconds to get the data....
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel
colporteur over 6 years ago in reply to manikandan341

What is your knowledge level and experience with i2C?

What systems areas have you been exposed to? (i.e. are use i2C to setup by RTC on a Raspberry Pi is different than a system developer using the protocol to control CNC press machines).

Sean
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel

Comment

colporteur over 6 years ago in reply to manikandan341

What is your knowledge level and experience with i2C?

What systems areas have you been exposed to? (i.e. are use i2C to setup by RTC on a Raspberry Pi is different than a system developer using the protocol to control CNC press machines).

Sean
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel

Children

manikandan341 over 6 years ago in reply to colporteur

we are write the data into eeprom and read using renesas controller .
- Cancel
- Vote Up 0 Vote Down
- Sign in to reply
- More
- Cancel