Please, help needed by Mechanical engineer new to Arduino. I have been trying with no sucess to bring together the (analog) output of a AM3X accelermoeter module with the debounce output (digital) of two tilt switches. I'm trying to get an output after debounce on one tilt switch is high and the other low (digital) and the gyro is in a set (greater/lower) output, and then the same in the opposite direction (tilt). This is for a small mechanical project. I'm really finding it hard to get the electronics sorted out (hours and hours of trying). I have managed to get the two individual (gyro, tilt switch) sketches to work seperatly, but can not get them to work together. Any help would be greatfully received. Sorry if this is an easy task I'm a newbe to electronics.Thank! Bootneck.