Have a question about Arduino? Ask me!

This thread has been closed to new questions.

However, we welcome you to Post Your Questionabout Arduino in the element14 Community Arduino group. You'll find many fellow members and experts who have just the answer you're looking to find!

Thank You, Your Friends at element14 Community

Jeremy Blum

Jeremy is an Electrical and Computer Engineering Student at Cornell University. He has been building microcontroller projects since high school, from a prototype prosthetic hand with a novel control scheme, to a nerf gun that fires at the intruders and uploads their picture to the web.

Top Replies

Parents

bobcroft over 15 years ago

Jeremy, can the AVR studio 5 be used for programming the Arduinos instead of the basic Arduino IDE?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
e14 Contributor over 15 years ago in reply to bobcroft

Hi,
what is a problem? now I buy a new chip ATMEGA328P-PUATMEGA328P-PU, my arduino uno works good,but can't upload job, I see problem text:
Binary sketch size: 1018 bytes (of a 32256 byte maximum)
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

How fix this problem?
thanks for answer
Bye
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
dmaruska over 15 years ago in reply to e14 Contributor

Where did you buy the chip, was the Boot loader already installed? If not I would start there.

Regards,

Dave M.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
bobcroft over 15 years ago in reply to e14 Contributor

Hi, I had exactly the same problem with a FreeDuino board. check that you have the correct board and COM port selected. I also slowed down the serial data rate in the 'boards' file from 115200 to 57600. Try googling the error message there are a number of threads.

It appears this fault (error) is common on the Arduino but I could find no definitve fix. However when I slowed down the serial transmission speed it fixed the Freeduino BUT this used the FTDI chip to translate USB to serial. I bel;ieve the Arduino uses a different chip.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
sciguy14 over 15 years ago in reply to e14 Contributor

You need to burn the arduino bootloader onto the atmega chip before you can program it with the arduino IDE.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

sciguy14 over 15 years ago in reply to e14 Contributor

You need to burn the arduino bootloader onto the atmega chip before you can program it with the arduino IDE.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data