Programming AVR with USBASP V2.0

Question

I want to program my Attiny85 with the USBASP v2.0 but i can't get any IDE.

I've read some post of Installing the Eclipse with the AVR Plug in, but I can't get it to work.

Also I tried with mikroC Pro for AVR, and still can't make it work with the USASP V2.0

I Already Installed the WinAVR

What can I do?

fidelsalinas · Accepted Answer

You can use avrdude with this command (avrdude -c usbasp -p AVRChipModel -U directory/to/.hex)

Here is a good tutorial on using avrdude.

http://www.ladyada.net/learn/avr/avrdude.html

Good luck,

Fidel Salinas

Robert Peter Oakes · Answer

If you have an Arduino UNO, you can set this up to program other ATMEGA chips, this is not exactly what your asking but it will get you going

http://www.instructables.com/id/How-to-program-attiny-using-arduino-uno/

Oh and the IDE from the Arduino site should also suffice to program the Tiny chips, the instructions with the link should provide you the relevant info

Regards

Former Member · Answer

I want to burn the program into my ATmega controller using USBASPV2.0.

I think you have achived this

can you tel me how to do this.

Required steps to fallow to achive this?

any softwares are required to do this?

Programming AVR with USBASP V2.0

Top Replies