can not program fpga

I am using PicoZed 7030 SOM + FMC Carrier V1 board and I am trying the tutorials for the Picozed. I am currently in the second one and I am trying to program my board but the board doesn;t open as seen in pdf. The first set of leds are 3 red and 2 green on and SDK can't program fpga. I put the sw1 correct and i am using only one usb cable connected to usb - uart port. Any guests?

Thank you!

Parents

0 bhfletcher over 7 years ago

You program the Zynq with a USB-JTAG cable. I suggest the www.avnet.me/jtaghs3.
You can also program the Zynq from the SD Card. Skip ahead to Tutorial 4 to see instructions on how to do this.
Bryan
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 bhfletcher over 7 years ago

You program the Zynq with a USB-JTAG cable. I suggest the www.avnet.me/jtaghs3.
You can also program the Zynq from the SD Card. Skip ahead to Tutorial 4 to see instructions on how to do this.
Bryan
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data