ZED Board VIA Position (Bottom side)

Question

I want to check the via position on bottom side of PCB with the pin number below.

J20,J21,J22, K21, M19,M20, N22, P20, P21, P22

I used FMC Connector for LVDS.

But it is presumed that the signal distortion occurs and I want to apply the terminal resistance.

I would like to attach a resistor to the copper foil(via) but it is too hard to verify its position.

asherkim · Accepted Answer

I solved this problem. But I received an answer from the distributor that DIGILENT can not support the PCB Project. So, I used PDF gerbers with laser printer.