Writing in gpio adresses

Hi everyone,

I'm quite new to programming and the Zynq/Zedboard and I would like to know how I can write values to the address range of my added axi gpio to zynq?

As you can see in the picture the Offset to High is 0x4000_0000 to 0x4000_ffff. How can I handle with? For example writing a value to address 0x4000_0000?

http://up.picr.de/28303885ec.png

Thank you in advance

tdirks

0 jafoste4 over 8 years ago

Hi Tdirks,
If you are new to ZedBoard, I am going to suggest you complete our Developing Zynq Hardware and Developing Zynq Software Speedways we offer.
http://zedboard.org/support/trainings-and-videos
Going through those speedways should solve your issue. If not take a look at the MicroZed Chronicles
http://zedboard.org/content/microzed-chronicles
For any further questions please post them over at the Digilent forum as they are the main source of contance for educational support.
https://forum.digilentinc.com/
Thank you,
Josh
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel