I have just acquired a minized starter kit; the installation according to the getting starter guide went well until the USB thumb drive should be installed/recognized by the board; I am using a 16GB HAMA USB3.0/MiniUSB2.0 sticker (format as FAT32); what c

Question

I have just acquired a minized starter kit; the installation according to the getting starter guide went well until the USB thumb drive should be installed/recognized by the board; I am using a 16GB HAMA USB3.0/MiniUSB2.0 sticker (format as FAT32); what could be wrong?

drozwood90 · Answer

Hi there,

Make sure you are using the aux power port to provide power. Without that, the USB will not properly read something that needs to be powered.

You can refer to the schematic to see the circuit and understand what is going on.

--Dan