I am using Vivado 2014.3 and I created a bunch of GPIO using AXI.
So, in order for the MicroZed to route the GPIO to eMIO to the carrier board, I need to specify the physical I/O pin number to each one. So where do I do this step?
I am using Vivado 2014.3 and I created a bunch of GPIO using AXI.
So, in order for the MicroZed to route the GPIO to eMIO to the carrier board, I need to specify the physical I/O pin number to each one. So where do I do this step?
I think this post addresses it:
http://zedboard.com/content/how-re-route-ps-gpiomio-emio-pin-xps
I also highly recommend the MicroZed Chronicles:
http://zedboard.org/content/microzed-chronicles
Bryan
I think this post addresses it:
http://zedboard.com/content/how-re-route-ps-gpiomio-emio-pin-xps
I also highly recommend the MicroZed Chronicles:
http://zedboard.org/content/microzed-chronicles
Bryan