Hi,
I would like to use 2.5V supply on FMC carrier card v2 to drive a custom board. What is the maximum current I can draw from this 2.5V supply?
Regards,
Engin
Hi,
I would like to use 2.5V supply on FMC carrier card v2 to drive a custom board. What is the maximum current I can draw from this 2.5V supply?
Regards,
Engin
Hi Engin,
The FMC VADJ output was designed for 2A, please refer to the power documentation located here - http://zedboard.org/sites/default/files/documentations/PicoZed%20FMC%20Carrier%20V2%20Power%20Analysis%20160412.zip
If for some reason the hyperlink doesn't work, look under the documentation section on the FMC V2 and you will see a link for Power Analysis. It includes the board level power budgeting. The output was designed for a worst case of 3A, but with current draw from other sources I wouldn't push the FMC current much beyond 2A and definitely keep it below 2.5A.
Thanks
Chris
Hi Engin,
The FMC VADJ output was designed for 2A, please refer to the power documentation located here - http://zedboard.org/sites/default/files/documentations/PicoZed%20FMC%20Carrier%20V2%20Power%20Analysis%20160412.zip
If for some reason the hyperlink doesn't work, look under the documentation section on the FMC V2 and you will see a link for Power Analysis. It includes the board level power budgeting. The output was designed for a worst case of 3A, but with current draw from other sources I wouldn't push the FMC current much beyond 2A and definitely keep it below 2.5A.
Thanks
Chris